User's Manual
nal connection of the system
With receiver/amplier located, speaker and sensor cables neatly routed, we are ready to complete the
installation.
1. Cut the speaker wire to the appropriate length
2. Strip about
3
/8” o the end of each speaker wire.
3. Twist the wire and if you have a soldering iron, tin the wire ends
4. Unplug the phoenix connector from amplier. Reference amplier insert diagram on amplier
(Figure H) (+) wire (with printed writing) into either outside (+) terminal.
5. Plug the other (-) wire into center (-).
speaker installation
5. Tighten set screws.
6. Repeat for other pair and insert plug rmly into speaker output receptacle.
7. Plug amplier power supply into AC outlet.
8. Connect audio sources and set output to desired levels.
Figure H
Speaker Output Phoenix Connector
16