User's Manual

Optional:

Two Additional Speakers

installing SP-2000 wall mount speakers

•

First observe the shape of the room: ceiling height, door

locations, windows, mounting surface, and seating area

• Ordinary installation would be to locate the speakers

on each side wall approximately even with the front row

of listeners

• Mount the speakers 6–7 feet above the  oor

• Install the mounting brackets in the vertical (up/down)

orientation

• Mount brackets using the appropriate hardware

• Insert speaker with the tweeter in upper position

• Secure speaker in bracket with the hand fasteners

• Orient each speaker toward the center of that half of the

listening area

• Strip speaker cable ends ½” and connect to speaker

• Observe speaker polarity: Connect (+) wire (with printed

writing) to (+) terminal and (-) wire (unprinted &

textured) to the (-) terminal

• Route speaker cable to the receiver/ampli er in a safe,

least visible, tidy manner

final connection of the system

With receiver/ampli er located, speaker and sensor cables

neatly routed, we are ready to complete the installation.

• Cut the speaker wire to the appropriate length

• Strip about

/8” o the end of each speaker wire.

• Twist the wire and if you have a soldering iron, tin

the wire ends

• Unplug the phoenix connector, insert (+) wire (with

printed writing) into either outside (+) terminal. Plug

the other (-) wire into center (-).

• Tighten set screws.

• Repeat for other pair and insert plug  rmly into

speaker receptacle

• Plug power supply into AC outlet