Instructions/Assembly Guide

3
Correct
Incorrect
Some burrs are left at the edge of plastic parts after cutting them off.
Make sure the burrs are completely removed to avoid operation malfunction.
Remove burrs
Fasten tapping screws
Shape, assembly direction, and position of parts
Unnecessary
burrs
Unnecessary
burrs
Trim off the burrs ONLY. Do not
trim off the protrusion of the original
plastic parts. All features of parts
should be kept completely.
Use corresponding (size-compatible) screwdriver. By following steps
below, you can fasten the tapping screws perfectly.
Some parts may look quite similar. They should be assembled in the designated direction and position shown in manual.
Coding buttons can be removed for new programming. Remove them straight up off the coding wheel. Do not torque them to
avoid damage.
Put the screwdriver
towards the top of
screws.
(1) Screw in
(2) Feel the tension getting higher
(3) Keep screwing
Please lock screws all the way
down to the bottom. If they are not
fastened tightly enough, parts may
come off. The robot may
consequently not work.
Repeat until
screws are
tightly fastened.
Please Read Before Assembly
Incorrect
Correct
Incorrect
Correct
Correct
Incorrect
Correct
Correct Correct
Incorrect
Incorrect Incorrect