Instructions/Assembly Guide

E5x10

Parts Required:

E8x5

Drawing-bot

Insert the Coding buttons as shown.

Note the position and sequence on both sides of the coding

CODING

Video Tips

View a video on this project at https://www.elenco.com/teachtech/

Start point

10 pcs

5 pcs

CODING WHEEL

Left side

CODING WHEEL

Right side

1. If it does not follow the coding program correctly, please go back to page 21 step 2

to check if parts D3 and C15 are assembled in the right way.

2. Check the coding buttons and wheel installation.

3. See page 37

Trouble Shooting

First test the program with the pen cap on. Place the unit on a 2.5’ x 2.5’ piece of paper. Turn the Draw-BOT on,

it moves forward then draws a 13’ diameter circle. Note: Turn the unit off before it repeats the program. Now,

remove the pen cap and run the program again. Using the coding buttons create your own program.