Datasheet

ManualsBrandsTEAC Manualsaudio & home theatreHP-7D-R

CE - Declaration of conformity

We herewith declare, that the TEAC MEDIA SYSTEMS HP-7D

complies with the following norms or normative documents:

EMC Directive 89/336 / EEC;

EN 55022 : 1998 + A1 : 2000 + A2 : 2003

EN 55024 : 1998 + A1 : 2001 + A2 : 2003 (EN 61000-4-2 / -3)

This statement is based on the test reports of an EMV - laboratory.

All texts and illustrations were produced with utmost care. TEAC MEDIA

SYSTEMS cannot however accept any legal or other responsibility for any

remaining incorrect information and its consequences.

Subject to change without further notice.

In case there is audible noise,

possibly caused be strong radio waves (e.g. by mobile phones)

we recommend to turn down the volume control of the unit.

If you have special questions to the product and cannot find a solution in this

introduction, you can look for more informations at our homepage

www.teac.de

HP-7D

USER MANUAL

Summary of content (5 pages)

PAGE 1
www.teac.de If you have special questions to the product and cannot find a solution in this introduction, you can look for more informations at our homepage In case there is audible noise, possibly caused be strong radio waves (e.g. by mobile phones) we recommend to turn down the volume control of the unit. All texts and illustrations were produced with utmost care. TEAC MEDIA SYSTEMS cannot however accept any legal or other responsibility for any remaining incorrect information and its consequences.
PAGE 2
4. Please keep the product in a ventilated area and away from high temperature place, no direct sunlight, damply or dusty environment. Also avoid placing on top of heat radiating objects. 3. Before switching on the power of 5.1 headphone control box, please turn the master volume of your computer down. Adjust to desired volume after the product is working properly. Doing so, will prevent damage to 5.1 speaker units and also prevent of shock by unexpected signal volumes. 2.
PAGE 3
Ahead of the above mentioned basic control functions, there are various settings to adjust the sound quality and to have additional functions of the USB headphone, controlled by the driver/software supplied with the product. Microphone switch: Select on/off for the built-in microphone. “On” indication by LED light. Volume control: step master volume up and down by pressing the Volume + or Volume – buttons. Power switch: Select on/off for the USB 5.1 headphone system by the slide switch.
PAGE 4
Microphone Recording Advance Setting Microphone Recording Volume Switch Microphone Recording Volume Control Stereo Mix Switch Stereo Mix Volume Stereo Mix Balance 3. Record Volume Balance Add New User-Defined Item Microphone Advance Settings You can change your voice to Monster, Cartoon, Male, Female by pressing the Magic Voice function buttons. Microphone Echo Volume Control. Microphone Echo/ Magic Voice function Magic Voice functions Reset switch. Magic Voice Power Switch 6.
PAGE 5
. Please adjust a USB webcam to minimum bandwidth while using 5.1 USB headphone at the same time. To proceed, please follow these steps: Open the webcam window; click OPTIONS and select VIDEO CAPTURE FILTER; un-select USB auto bandwidth on control mode; adjust the USB to minimum bandwidth; Select APPLY, and CONFIRM, then EXIT; Restart to resume work normally. There is no need to reset next time! 4. In the case of more then one USB device is used with 5.