User`s manual

11.20 Quick Compare
20 TEAC Tower DVD Duplicator User’s Manual
If you have not set any DVD writer to copy using function 11.5, the Auto Close
Tray
function will be invalid. If function 11.5 is valid, you can set for the writer’s
tray to close automatically after copying finishes. You can specify tray closure to
occur within 5 to 50 seconds.
11.20 Quick Compare
With the Quick Compare function, you can specify a comparison of the source and
the copied target discs in increments of 1byte through 100MB.
11.21 Audio Burn Speed
Use the Audio Burn Speed function to specify the write speed at which audio CDs
will be recorded.
12 Advanced Setup (Adv Setup)
The Advanced Setup functions enable you to modify the system configuration.
You should make changes only after you become completely familiar with the
functions in this menu. To enter Advanced Setup mode, press the ESC button for
two (2) seconds.
12.1 UnderRun Protect
The UnderRun Protect setting turns Buffer UnderRun Protection on or off. The
default setting is ON.
12.2 Overburn
The Overburn setting turns the Overburn function in the target drive on or off. The
default setting is OFF.
12.3 Read Error Skip
The Read Error Skip setting controls error skipping during reading of the source
disc.
If the setting is OFF and an error is detected, the target drive stops and displays
the read error message.
If the setting is ON, no messages will be displayed if an error occurs. The copy
operation will be completed and the copy will include all errors detected during
the process.
The default setting is OFF.
TEACdvwd17h.book Page 20 Sunday, May 1, 2005 6:28 PM