Cassette Player User Manual

17
ENGLISH
Continuous recording
This function allows you to make uninterrupted recordings on both
sides of two tapes.
1
Load cassette tapes for recording into the TAPE I and
TAPE II compartments.
Side “A” facing you
2
Set the REV MODE switch to the p (CONT REC/PLAY)
position.
Set the DOLBY NR switch to the ON position if you want to.
3
Press the TAPE I deck’s RECORD (K) key.
The deck enters the record-pause mode. J and will light
on the display. Now adjust the recording level and any other
settings, as required.
4
Check the recording direction.
If an indicator is lit which points in the direction opposite to
the one desired, change the direction by pressing the opposite
direction PLAY (h or y) key.
NOTE
Be careful not to press the PLAY (h or y) key whose arrow
points in the same direction as the indicator. Doing so will start
recording.
Recording is done in this order:
TAPE I Side “A”
x
Side “B”
x
TAPE II Side “A”
x
Side “B”
You can start recording from side “B” of TAPE I. But if you do so,
side “A” of this tape is not recorded: when recording reaches the
end of side “B”, the TAPE II deck starts recording.
NOTE
The TAPE II deck always starts recording from side “A”.
5
Start recording.
Recording starts when you press the PAUSE key or the PLAY
(h or y) key whose arrow points in the same direction as the
indicator on the TAPE I deck.
When recording is finished on the TAPE I deck, the TAPE II deck
automatically starts recording.
NOTE
The transition from TAPE I to TAPE II takes several seconds.
A
To stop recording
Press the STOP (H) key of the deck which is currently recording.