Information

PAGE 3
Universal connector block Terminal strips and push-wire connectors
Universal connector
block for RayGel
Plus 2/3 joints
With the unique universal
connector block installation
is very straightforward, as the
block snaps into the bottom side
of the enclosure.
A supplementary tool helps
to insert the sliding nuts and
holds them in place until the
connection is finalised.
Connector block CB5
for RayGel Plus 1.5
joints
This very compact connector
solution can be used for straight
connections, where space in
installation is limited.
Connector
recommendation for
RayGel Plus 0/1/1.5
All types which dimensionally
fit into the enclosure, such
as terminal strips, push-wire
connectors, mechanical blocks
and crimp connectors.
RayGel Plus 2 joint with connector installed
CB5 connector block
RayGel Plus Joints filled with PowerGel
for single and multi-core polymeric cables 0.6/1 kV
Easy to install
Closing the rugged RayGel Plus enclosure is literally
a snap. Its short length also allows installation in
cramped locations. No special tools needed, no rip
cords to break, and no trimming, mixing, pouring, or
heating required; RayGel Plus joints can be put into
service immediately.
Kit content
PowerGel filled enclosure, universal connector block
including sliding nut insertion tool and allen key (for
RayGel Plus 2/3 joints), tie wraps for a strain relief of
the cables and illustrated installation instructions.
All joints are available in one piece packaging.
RayGel Plus 2/3 kit content