Datasheet

CRIMPAC, 8-1579024-6
OPERATING
INSTRUCTION
S
411-18628-1
Page 8 - 9
Figure 2: Ratchet release
 Push the ratchet release downwards until the ratchet is released.
 Open the handle.
 Remove the terminal from the crimping jaws.
 Check the function of the crimping tool.
The ratchet must automatically release at the end of the crimping process.
 The crimping tool is ready to use again.
6 Repair and maintenance
6.1 Daily maintenance
The following daily maintenance must be carried out by the responsible operator:
 Using a clean, soft brush or a lint-free cloth, remove dirt, dust, moisture and other
residues from the crimping tool. Do not use any hard or abrasive materials that could
damage the crimping tool.
 Apply sewing machine oil to all pivot points and bearing surfaces. Avoid excessive
lubrication.
 The crimping tool must be stored in a clean and dry location when not in use.
6.2 Periodic inspection
 The crimping tool should be inspected regularly by suitably qualified personnel, de-
pending on the level of use, and the inspections should be documented.
 Check the crimping tool for wear and damage, particularly in the area of the crimping
nests.
7 Disposal
The crimping tool can be disposed of as normal waste or as recyclable waste where pos-
sible. Disposal must always comply with local regulations. If in doubt, the crimping tool
can be sent to TE for disposal.