Datasheet

108-20020
Rev. D3 Page 2
of 7
LOC I
FTEC174 rev. 1 July 99
3.
TEST REQUIREMENTS AND PROCEDURE SUMMARY
TEST DESCRIPTION PROCEDURE REQUIREMENT
P R O D U C T E X A M I N A T I O N
3.1 Visual examination Product shall be in accordance
with the requirements of
production drawing.
Visual, dimensional and functional
check.
M E C H A N I C A L R E Q U I R E M E N T S
1° Cycle 3.2 Connector mating
force
Female connector mated with
proper tab connector (locking
device not operating).
Perform test at a rate of 25-50
mm/minute
44N Max
25N Max
35N Max
40N Max
per pole for 2.8, 4.8 mm
srs.
per pole for 6.3 mm srs.
per pole for 7.9, 9.5 mm
srs.
per pole for 6.3 mm srs.
when receptacle with
dimple and tab with hole
have been used.
1° Cycle 10° cycle 3.3 Connector unmating
force
Not greater than
connector mating
force value.
This is not
applicable to
receptacle contact
with dimple and tab
with hole.
4N Min.per pole
for Brass and
Phos. Bronze
versions, 13N
Min. per pole for
Steel nickel
plated versions.
3.4 Engaging force 40N Max
22N Max
32N Max
38N Max
Per pole for 2.8. 4.8 mm
srs.
For 6.3 mm srs.
For 7.9, 9.5 mm srs.
For 6.3 mm srs. when
receptacle with dimple and
tab with hole have been
used.
1° Cycle 10° cycle 3.5 Separating force
Single receptacle contact mated
with tab contact
Not greater than
engaging force
value.
This is not applicable
to receptacle contact
with dimple and tab
with hole.
4N Min.for
Brass and
Phos. Bronze
versions, 13N
Min. for Steel
nickel plated
versions.
3.6 Durability 10 mating/unmating operations