Datasheet

408-6929
Terminating Head 58246-1
Rev D4 of5
Tyco Electronics Corporation
Figure 5
Wire
Pistol Grip Handle
Assembly (Manual Shown)
Left Side
of Head
Feed Slide
Tool Base
Index Rib of
Connector
Locating
Pawl
Funnel Area
6.3. Inspection
Regular inspections should be performed by quality
control personnel with a record of quality control
inspections remaining with the personnel responsible
for the head. One inspection per month is the
recommended frequency; however, operator training
and skill, amount of use, working conditions, and
established company standards are all factors to be
considered in establishing inspection frequency.
7. REPLACEMENT AND REPAIR
Customer–replaceable parts are listed in Figure 6.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed
should be replaced by Tyco Electronics Corporation
to ensure quality and reliability. Order replacement
parts through your representative, or call
1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
For customer repair service, call 1–800–526–5136.
8. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements
S Removed connector part numbers
S Modified Figure 3
S Modified Step 5 of Paragraph 3.1 and Point 1
of Paragraph 3.2
S Modified Step 2 of Section 4
S Added phone number for customer repair
service