Datasheet

408- 7514
Rev E2 of 2
Precision Formed Contact
With
Insulation Support
Precision Formed Contact
Without
Insulation Support
Socket
(Typ)
Pin
(Typ)
CONTACT DESCRIPTION WIRE SIZE RANGE (AWG) INSULATION DIAMETER (MAX) HAND TOOL (DOCUMENT)
Precision Formed Contact
28--24 1.02 [.040]
91503--1 (408--8547)
o
r
P
r
e
c
i
s
i
o
n
F
o
r
m
e
d
C
o
n
t
a
c
t
With Insulation Support
24--20 1.52 [.060]
or
58448--2 (408--9357)
Precision Formed Contact
28--24 1.73 [.068]
9
1
5
4
8
1
(
4
0
8
8
5
4
7
)
P
r
e
c
i
s
i
o
n
F
o
r
m
e
d
C
o
n
t
a
c
t
Without Insulation Support
24--20 1.73 [.068]
91548--1
(
408--8547
)
Figure 2
4. HARDWARE
A shield and cable clamp assembly is used with the
connector to house the cable or wire projecting from
the rear of the connector and for strain relief of the
cable or wires. For additional information concerning
the use of the shield and cable clamp assembly, refer
to Instruction Sheet 408--7555.
Shielded cable clamp kits for AMPLIMITE HDP--20
connectors used with braid and foil--shielded cables
are available in all connector sizes. The cable clamps
may be used with latching blocks (208101, 745245,
and 745286) and spring latches (745255--1) for
panel--mounted or free--hanging applications. Refer to
Instruction Sheet 408--6609 for additional information.
A male screw retainer kit (5205980--1) and a female
screwlock kit (5205817--1) are used to secure mating
connectors in panel--mounted or free--hanging
applications. Refer to Instruction Sheet 408--7837 for
information.
A slide latch post kit (5206514--1) and a slide latch
clip kit (5206942--1) are also used to secure mating
connectors in panel--mounted or free--hanging
applications. For additional information, refer to
Instruction Sheet 408--6551.
Slide latch post kits and slide latches for all
AMPLIMITE HDP--20 connector sizes are available
for panel--mounted and free--hanging applications.
Refer to Instruction Sheet 408--6551 for slide latch
and slide latch post application procedure and
information.
5. PANEL CUTOUT
Before making the panel cutout, refer to Application
Specification 114--40030 to determine the number of
positions in the connector , whether it will be used with
a cable clamp or side latch, and what the required
dimensions and clearances must be.
6. REVISION SUMMARY
Since the previous release of this sheet, the following
changes were made:
S Updated document to corporate requirements