Datasheet

Rast 5
2
2013
AMP MONO-SHAPE
Connectors in In-Line Mating Technology
Catalogue 1654742
Revised 5-04
Dimensions are in inches and
millimetres unless otherwise
specified. Values in brackets
are metric equivalents.
Dimensions are shown for
reference purposes only.
Conversion Rate:
25.4mm = 1 inch
Products for Industrial &
Commercial Applications
Specifications subject to
change.
www.tycoelectronics.com
Introduction
METRIC
Dimensions are
millimetres over inches
AMP MONO-SHAPE
Connectors in In-Line
Mating Technology
AMP MONO-SHAPE connectors
represent a valid solution to the
ever-increasing requirements
for production and application
flexibility.They are high
productivity, great flexibility,
quality, minimum applied cost.
AMP MONO-SHAPE product-
line includes a full range of 5.0
mm pitch modular connectors
contents with similar outer
shape, several variation in the
mating area such as PC Board
and 6.3 x 0.8 mm tabs (RAST
5), plus a version for harness
shunts.
AMP MONO-SHAPE connection
system adopts the IDC
termination technology,which
improves application results
and quality level.
The AMP MONO-SHAPE
product range,combined with
the performances and
properties offered by the
termination system,allow to
manufacture extremely
complicated harness structures
while still maintaining high
production levels.
■ IDC Connector system
design to maximise the
full integration with the
application tooling assuring
total flexibility in harness
design.
■ High current system, up
to16 Ampere, designed to
satisfy several appliance
requirements.
■ ID Contact designed to
accept standard discrete
wires ranging from 0.5 up to
1.5 mm
2
,according to the
connector configuration.
■ The connector incorporates
modern in-line mating
technology on a 5.0 mm
centerline with no loss of
spacing and a variety of
keying possibilities.
■ Wiring faults eliminated
through high automation.
■ Approvals:
VDE: 4751-1431-4024 / A
10A and
4751-1431-4024 / A 9E
UL E 28476 Vol. 9 Sec. 7;
97 ME 17936; AP-27HB
Technical Features