Datasheet

108-36034
Rev A 2 of 6
3.4. Performance and Test Description
The product is designed to meet the electrical, mechanical and environmental performance
requirements specified in Figure 1. All tests are performed at ambient temperature unless otherwise
specified.
3.5. Test Requirements and Procedures Summary
Test Description Requirement Procedure
Examination of Product Meets requirements of product
drawing and Application
Specification 114-10002.
Visual, dimensional and functional
per applicable quality inspection
plan.
ELECTRICAL
Termination Resistance, Specified
Current
See Figure 4 Measure potential drop of mated
contacts assembled in housing,
see Figure 6; Test Specification
109-25, calculate resistance.
Dielectric Withstanding Voltage See Figure 5
3 minutes hold. No break-down or
flashover; 1 milliampere maximum
leakage current.
Test between contacts of mated
connector assembly and ground;
Test Specification 109-29-1
Insulation Resistance 5000 megohms minimum initial. Test between contacts of mated
connector assembly and ground;
Test Specification 109-28-4.
Temperature Rise vs Current 30°C maximum T-Rise at 15
amperes for type XII contact.
Measure T-Rise vs current; Test
Specification 109-45-1.
Vibration, Sinusoidal Low
Frequency
No discontinuities greater than 1.0
microsecond. See Note.
Subject mated connectors to 10-
55-10 Hz traversed in 1 minute at
0.06 inch total excursion; 2 hours
in each of 3 mutually perpendicular
planes;
Test Specification 109-21-1.
Physical Shock No discontinuities greater than 1.0
microsecond. See Note.
Subject mated connectors to 30
G's sawtooth shock pulses of 11
milliseconds duration; 3 shocks in
each direction applied along the 3
mutually perpendicular planes total
18 shocks;
Test Specification 109-26-7
Mating Force Type
Contact
III+
XI
XII
Force, Pounds
Maximum
3
2
15
Measure force necessary to mate
connector assembly with coupling
rings inactivated incorporating free
floating fixture at a rate of .5
inch/per minute; Test Specification
109-42, cond A.
Min. Ounces minimum per contact. Contact Separating Force
Type III+
Type XI
Type XII
1.5
.75
5.0
Size 3 times using gage as
indicated in Figure 7, insert gage
and measure force to separate;
Test Specification 109-35,
separation depth Figure 7.
Durability No physical damage. Mate and unmate connector
assembly for 500 cycles at a
maximum rate of cycles/hour; Test
Specification 109-27.
Figure 1 (continued)