Data Sheet

SWS1000L
(5) Bench handing test
(MIL-STD-810F 516.5 Procedure VI)
1. Purpose
Test based on [MIL-STD-810F 516.5 Procedure VI - Bench handing].
2. Test method
Unit was taken directly from production line.Unit was compliant with production standards
.
Use test bench with thickness of at least 4.25cm.
With unit switched off.
Raise until the chassis forms an angle of 45° with the bench top.
Drop unit on each face on which unit could be placed practically.
In the above test method, repeat drop 4 times in total.
3. Acceptable conditions
During shock test,no destruction in the test unit.
After shock test,no abnormality in the electric characteristics and the mechanism.
4. Test result
OK
DENSEI-LAMBDA
R-17