Datasheet

SWS1000L
INDEX
1. Evaluation Method PAGE
1.1 Circuit used for determination
.
..................................
.
T-1~5
(1) Steady state data
(2) Warm up voltage drift characteristics
(3) Over current protection (OCP) characteristics
(4) Over voltage protection (OVP) characteristics
(5) Output rise characteristics
(6) Output fall characteristics
(7) Output rise characteristics with ON/OFF CONTROL
(8) Output fall characteristics with ON/OFF CONTROL
(9) Dynamic line response characteristics
(10) Dynamic load response characteristics
(11) Inrush current characteristics
(12) Leakage current characteristics
(13) Output ripple and noise waveform
(14) Standby current
(15) Electro-Magnetic Interference characteristics
1.2 List of equipment used .......................................
.
T-6
2. Characteristics
2.1 Steady state data
(1) Regulation - line and load, temperature drift
.
.......................
T-7
(2) Output voltage and Ripple noise voltage vs. input voltage
.
..............
.
T-8
(3) Efficiency and Input current vs. Output current
.
.....................
T-9
(4) Power factor and Input current vs. Output current ....................
T-10
2.2 Warm up voltage drift characteristics
.
.............................
T-11
2.3 Over current protection (OCP) characteristics
.
.......................
.
T-12~13
2.4 Over voltage protection (OVP) characteristics
.
.......................
T-14
2.5 Output rise characteristics .....................................
.
T-15~16
2.6 Output fall characteristics .....................................
.
T-17~18
DENSEI-LAMBDA