Instructions

WARNING

Hazardous voltages exist at the outputs and the load connections. To protect personnel against

accidental contact with hazardous voltages, ensure that the load and its connections have no

accessible live parts. Ensure that the load wiring insulation rating is greater than or equal to the

maximum output voltage of the power supply.

80V to 600V Models

Output Load Wires No Conductor Pretreatment: Phoenix Contact clamping parts are designed

so that all kinds of copper conductors can be clamped without pretreatment.

It is forbidden to solder the conductors. The solder tin yields and fractures under high pressure. The

result is increased contact resistance and an excessive temperature rise. In addition, corrosion

caused by pickling or fluxes has been observed on soldered conductor ends. Notch fractures at the

transition point from the rigid to the flexible conductor area are also possible.

CAUTION

Fig. 3-5: Load wires connection , 6V to 60V models.

M8x15 screw (2 places)

Hex Nut (2 places)

Flat washer (2 places)

Spring washer (2 places)

Wire terminal lug (2 places)

Flat washer

(2 places)

Screws tightening torque: 104-118 Lb-inch.

Fig. 3-6 Bus-bars

cover 6V to 50V

Fig. 3-7 Bus-bars

enclosure 60V

(Refer to Fig.3-8, 3-9 for installation instructions.)

Fix the bus-bars enclosure

top cover using the screws

marked “A”. Tighten the

screws after fixing.

Enclosure top cover

Enclosure

bottom cover

Fix the bus-bars enclosure top

cover using the screws marked

“A”. Loosen screw “B” to release

the shutter. Insert load wires

through enclosure bottom cover

opening and connect load wires.

Assemble the enclosure bottom

cover by using screw C. Tighten

screws “B” after sliding down the

shutter.