Datasheet

5|
Remote Programming via RS-232 & RS-485 Interface
LAN Interface
Standard Serial Interface allows daisy-chain control of up to 31
power supplies on the same communication bus with built-in
RS-232 & RS-485 Interface with or without Multi-Drop option.
P/N: IEMD
P/N: LAN
P/N: USB
• VISA & SCPI Compatible
• LAN Fault Indicators
• Auto-detects LAN Cross-over Cable
• Compatible with most standard Networks
• Allows IEEE Master to control up to 30 (Multi-Drop equipped) slaves over RS-485 daisy-chain
• Only the Master needs be equipped with IEEE Interface
• IEEE 488.2 SCPI Compliant
• Program Voltage • Program Current
• Measure Voltage • Measure Current
• Over Voltage setting and shutdown • Current Foldback shutdown
• Error and Status Messages
Programming Options (Factory installed)
New IEEE Multi-Drop Interface
New Multi-Drop Slave Option
• Slaves need to be equipped with the MD Slave (RS-485) option
• Four Channels to Program and Monitor Voltage and Current.
• Isolation allows operation with floating references in harsh electrical environments.
• Choose between programming with Voltage or Current.
• Connection via removable terminal block: Phoenix MC1,5/8-ST-3.81.
• Voltage Programming, user-selectable 0-5V or 0-10V signal.
Power supply Voltage and Current Programming Accuracy ±1%
Power supply Voltage and Current Monitoring Accuracy ±1.5%
Isolated Analog Programming
• Current Programming with 4-20mA signal.
Power supply Voltage and Current Programming Accuracy ±1%
Power supply Voltage and Current Monitoring Accuracy ±1.5%
P/N: IS420
P/N: IS510
• Meets all LXI-C Requirements
• Address Viewable on Front Panel
• Fixed and Dynamic Addressing
• Fast Startup
P/N: MD
• Allows Serial Connection to USB Port on computer
• Serial commands same as (standard) RS-232/RS-485 Interface
Genesys™ Power Parallel and Series Configurations
Up to two units may be connected in series to increase the output
voltage or to provide bipolar output. (Max 600V to Chassis Ground).
Active current sharing allows up to four identical units to be connected
in an auto-parallel configuration for four times the output power.
Series operation
Parallel operation - Master/Slave:
In Advanced Parallel Master/Slave Mode, total current is
programmed and reported by the Master. Up to four supplies
act as one.
USB Interface
Compliant to Class C
Genesys 750W/1500W-1U
TM