User manual
Table Of Contents
- Benutzerhandbuch
- Allgemeine Informationen
- Die Anwendung
- GenesysControl Konfiguration
- Allgemeine Konfiguration (“General configuration”)
- Geräte-Konfiguration (“Device configuration”)
- Die Control Session
GenesysControl 3.0 Benutzerhandbuch Rev1.2, Lambda GmbH
23
Die Alarm LEDs
Die Alarm LEDs zeigen den Alarm Grund eines Genesys Gerätes an. Die folgenden Alarme können
auftreten:
• AC: AC failure has occured.
• OTP: A shutdown due to an over temperature has occured.
• FOLD: A foldback shutdown has occured.
• OVP: An OVP shutdown has occured.
• SO: Rear panel “Shut Off” has occured.
• OFF: Front panel OUT button was pressed.
• ENA: Rear panel “Enable Terminal” has opened.