Information


2. PROGRAMMING COMMANDS
2.1 COMMAND NOTES
Expressions enclosed in square brackets, [ ], are optional and entered without the [ or ].
Expressions enclosed in greater than/less than, < >, are programming values and entered
without the < or >.
The expression <SP> represents a one character ASCII Space.
In all commands upper case characters can be interchanged with lower case characters.
WORD CAN BE REPLACED WITH
:AMPLITUDE :AMPL
:CONDITION :COND
:CURRENT :CURR
:ENABLE :ENAB
:ERROR? :ERR?
:EVENT :EVEN
GLOBAL GLOB
INSTRUMENT INST
:IMMEDIATE :IMM
:ISUMMARY1 :ISUM1
:ISUMMARY2 :ISUM2
:ISUMMARY3 :ISUM3
:LEVEL :LEV
:LIMIT :LIM
MEASURE MEAS
MODE? MOD?
:NSELECT :NSEL
:OPERATION :OPER
:OUTPUT OUTP
:PRESET :PRES
:PROTECTION :PROT
:QUESTIONABLE :QUES
:SELECT :SEL
SOURCE SOUR
:STATE :STAT
STATUS STAT
SYSTEM SYST
:TRIPPED :TRIP
:VERSION :VERS
:VOLTAGE :VOLT
2.2 PROGRAMMING AND MESUREMENT COMMANDS
2.2.1 PROGRAM OUTPUT VOLTAGE
The output voltage can be programmed by sending the command:
[SOURce]:VOLTage[:LEVel][:IMMediate][:AMPLitude]<SP> <value>
where <value> is any valid voltage with or without a decimal place.