Instructions

8. Configuration
Connect the device to a computer:
USB: Connect the device and the computer using a USB cable. The
device driver is installed automatically if the computer is connected to
the Internet.
XBEE: Insert the XBEE stick into the computer. The device driver is
installed automatically if the computer is connected to the Internet. In
order to reset the XBEE settings, short-circuit terminal J8.
RS485: Short-circuit terminal J8. Connect the device to the computer
using an RS485 USB adapter. After completing the configuration,
open J8 again.
Start the "Digalox Manager" software and connect it to the device. Settings can
then be made on the various tabs and saved in the device.
Please note that the measurement mode selected in “Digalox Manager” is displayed
only until the power supply of the DPM72 is interrupted.
In further operation, the device always shows the first
measurement mode or the one that is selected by the jumpers
J4-J6 (see table “Measurement mode”),
in case of a multi display style additionally the following measuring modes.
Table measurement mode (factory preset, can be changed by software)
Measurement mode Display Measurement
mode selection
1 10 V DC scaled
10 V
%
J1
J12
2 2-10 V DC scaled
2-10 V
%
J1
J12
3 20 mA DC scaled
20 mA
%
J1
J12
4 4-20 mA DC scaled
4-20 mA
%
J1
J12
----- 5 / 8 -----