Instructions

----- 4 -----
5. Configuration
The device can be configured via DIP switches and jumpers manually or with the
corresponding software “Digalox Manager” via USB interface. When configuring via
DIP switches and jumpers the basic settings can be made computer-independent.
The configuration with the software “Digalox Manager” allows full functionality.
Setting scale via DIP switch
In modes where a scaling is necessary to represent the correct measurement value
(for example 60mV DC for shunt or analogue signal) the upper scale value
corresponds to the primary value of the shunt or the maximum display value of the
analogue signal. Example:
upper scale value = 250 = primary value shunt
upper scale value = 100 = maximum display value of analogue signal
Configuration via USB interface with software “Digalox Manager”
Visit www.digalox.com to download software “Digalox Manager”. For use with
software set DIP switch 10 to OFF position.
Please note that the measuring mode selected in "Digalox Manager" is displayed
only until the power supply of the DPM72 is interrupted.
Configuration via DIP switches and jumpers if only one measurement mode is
required (Manual mode)
1. Set DIP switch 10 to ON position.
2. Set measurement mode with jumpers at J4-J6 according to table "Measurement
mode”, column “Manual mode".
3. Set upper scale caption for the first measurement mode with DIP switches 1-9
(see “Configuration of the upper scale caption”).
4. Connect supply voltage.
In further operation, the device always shows the measurement mode,
which is set by the jumpers J4-J6 or the DIP switches 11-12 respectively!
(see table "Measuring mode").