User's Manual

Introduction to Electronic Ballast for T5/54 and PLL/55Watts Fluorescent Lamp

This TDC Electronic Ballast is designed to drive one or two lamps of T5-54 Watts or

PLL-55 Watts Fluorescent lamps. The input voltage is between 100 to 277 VAC. It is

a top quality product to allow luminary manufacturers and users to produce elegant

products with especially high efficiency and good light control features. It will

increase the luminous flux and longer lamp life. This electronic ballast is extremely

beneficial on both economically and professionally.

Installation Notice

. Connect the lamps according to the label, the ballast is supported to use to the lamps

specified on the product label.

. Connections of power wires must be fully insulated.

. The installation of the electronic ballast must be carried out by a qualified

electrician.

. Isolate the main supply before installation of this product.

. The electronic ballast can only be used to supply the specified fluorescent lamps.

Replace lamps in time if the lamps have been too aging to operate. Turn off power

supply before replacing lamps.

. This electronic ballast can’t be used with a dimmer or in a dimming circuit.

. The power of lamp should be the same with the indicated value of this product.

Warning

This product complies with Part 18 FCC rules. This electronic ballast may cause

interference with radios, cordless telephone, or devices that use a wireless remote

control. If interference occurs, move the product away from the device or plug either

into a different outlet, or move the lamp out of the sight with the remote control

receiver.

This product could produce interference when used near 0.7V, radio, wireless remote

PAGE 1
Introduction to Electronic Ballast for T5/54 and PLL/55Watts Fluorescent Lamp This TDC Electronic Ballast is designed to drive one or two lamps of T5-54 Watts or PLL-55 Watts Fluorescent lamps. The input voltage is between 100 to 277 VAC. It is a top quality product to allow luminary manufacturers and users to produce elegant products with especially high efficiency and good light control features. It will increase the luminous flux and longer lamp life.
PAGE 2
control or maritime safety communication equipment, or other critical navigation of communication equipment operation between 0.45 to 30 MHz. If interference occur, move the lamp away from the appliance a distance of three feet or more, or plug the lamp or the appliance into a different outlet.