User Manual

62 Reader Data Interface PLUS System Manual
Proprietary Information: Do not disclose unless authorized under a Nondisclosure Agreement and the Partner Agreement.
Command
Meaning
RX 1
Enable the Reader. This causes the Reader to start listening
to Tag packets. The Reader is automatically enabled at
startup.
RX 0
Disable Reader. The Reader will stop listening for Tag
packets.
CAL 1
Enable power to Calibration Tag.
CAL 0
Disable power to Calibration Tag. Power to the Calibration
Tag is disabled at startup.
IP DHCP
Configure the Reader to acquire its IP address via DHCP.
IP ipaddr:mask[:gw]
Configure the Reader to use the static IP address ipaddr,
subnet mask mask, and gateway gw. The gateway parameter
is optional.
SOLVER AUTO
Configure the Reader to generate the location engine IP
address based on the Reader’s IP address and netmask.
SOLVER addr
Set IP address of location engine to addr. The Reader sends
all TOA packets to the location engine’s IP address.
OSC 1
Enable the internal oscillator. The internal oscillator should
be enabled when Reader is not connected to a SDP.
OSC 0
Disable the internal oscillator. The internal oscillator should
be disabled when Reader is connected to a SDP.
REBOOT
Reboot Reader.
SENDSTATUS
Causes Reader to reply with current status.
SENDVER
Causes Reader to reply with software and firmware version
information.
SENDSTATUSVER
Causes Reader to reply with status and version information.
SENDSTATS
Causes Reader to send statistics.
CLEARSTATS
Causes Reader to reset statistics fields to 0.
SENDALARMSTATUS
Causes Reader to send alarm status word.
SENDALARMENABLE
Causes Reader to send alarm enable word.
SETALARMENABLE a
Sets Reader’s alarm enable word to a.
CLEARALARM a
Clears alarm condition(s) a in Reader.
Figure 3-4: Reader Commands
The values specified by the IP, SOLVER, OSC, and SETALARMENABLE commands are stored in
flash and are persistent across reboots.