User Manual

PLUS System Manual System Installation 47
Proprietary Information: Do not disclose unless authorized under a Nondisclosure Agreement and the Partner Agreement.
Figure 2-43: No Stitching to Reader Rf90
7) After each group is successfully calibrated, save the current configuration containing the new
calibration results using the File menu Save Config or Save Config As… selections. The next
time Visualizer is run, it will restore the saved calibration settings without the need to repeat the
calibration process.
Repeat the calibration process until all groups in the system are calibrated. As you finish calibrating
each group, the Visualizer 2D MapView display and statistics screens may be used to monitor Tags in
the areas covered by those groups. Note that good Calibration Tag statistics are necessary but not
sufficient to guarantee a good calibration. The quality of the calibration should be verified by
observing locations of tags throughout the installation.