User Manual

22 System Installation PLUS System Manual
Proprietary Information: Do not disclose unless authorized under a Nondisclosure Agreement and the Partner Agreement.
5. Tilt the drop panel and insert it into the frame opening. Lower
the panel so that it is seated evenly on the Antenna frame.
6. Connect the proper Ethernet cable to SYNC IN port of the
Reader. Verify that the cable snaps into the connector firmly and
the Reader powers on (via Ethernet LEDs). If there are
additional Readers in the chain, connect the proper Ethernet cable
to the SYNC OUT port of the Reader.
Figure 2-12: Drop Panel
Installation (shown with
no Reader mounted)
7. Verify that the Reader has booted (via the POWER LED on
steady) and is able to receive Tag traffic, as indicated by a
blinking DATA light.
Reader LED Indicators
8. Close the drop panel and slide the latches into the locked
(outward) position.
Figure 2-13: Closed Panel
1) Ethernet
LEDs Blink
3) Tag Traffic
2) Power LED on
steady (after several
seconds)