User Manual

112 Visualizer PLUS System Manual
Proprietary Information: Do not disclose unless authorized under a Nondisclosure Agreement and the Partner Agreement.
Figure 5-14: 2D MapView Settings
 Set Data Input… – specify the source of the Reader data.
Figure 5-15: Set Data Input Dialog
o IP Address – Select the IP Address radio button to specify that TOA messages will be
received via the network and, using the dropdown list of available IP addresses, select the
connection on which to receive the data. Selecting the 0.0.0.0 IP address causes the
application to listen on all available network interfaces.
o Logfile – Select the Logfile radio button to specify that the TOA messages will be read
from a logfile. Use the Browse button to identify the name of this input logfile.
Select Play back at maximum speed to replay the logfile at maximum speed rather than
the rate it was recorded.
Select Loop playback to repeat the logfile when it is finished.
Filter Settings… – specify the parameters for the Speed Limit and Averaging filters used by the PLUS