User's Manual

P330 Data Sheet / User Guide 37
DRAFT
6 Technical Specifications
6.1 Summary of Key Performance Parameters
Table 6-1 summarizes the P330 specifications and key performance parameters. For additional detail
on the performance of the DW1000 UWB chip see Decawave’s DW1000 User Manual and Data
Sheet. Note that the P330 uses a subset of the DW1000 RF channels. For a discussion on which
channels were implemented see Section 4.7 RF Transmit and Receive.
P330 Specs
Value
Physical Parameters
Board Dimensions (without SMAs):
3.5 x 2.2 inches (89 x 56 mm)
Assembly height (bottom to top
connectors):
0.703 inches (17.9 mm)
Weight:
1.6 ounces (45 grams)
Storage Temperature:
-40
o
C to 85
o
C
Operating Temperature range:
Industrial units:
-40
o
C to 85
o
C
Max allowable board temperature:
85c as reported by on board temp sensor
Humidity:
Up to 95%, non-condensing
Vibration:
Designed to meet most vibration specs. Existing
customers have already tested the P330 for operation in
extreme vibration environments.
Power & Ground & Boot Times
Input Power Range:
5.0 V to 48 V DC
Input Power Ripple:
100 mV pk-pk
Power Protection:
Reverse voltage
Electrostatic Discharge Protection:
+/-8kV contact discharge and
+/-15kV air-gap discharge
Chassis Ground:
Available. See Section 4.3.4 for details
Time from power on to completion of
boot:
11 seconds (no cables connected, with Serial connected
or USB connected, or no cables connected)
7 seconds (Ethernet connected)
Minimum time the power must be
turned off to force the processor to reboot:
1 second
Power & Temperature when Operating
as a Ranging Radio
Typical Power Consumption (board
temp 40
o
C, Vin= 5.0 V with state
transition times shown)
- Active (transmitting)
- Active (receiving)
- IDLE, Standby_E, Standby_S
1.0 Watts
1.0 Watts
0.5 Watts (Enter: 1.2 ms, Exit: 1.2 ms)
Operating Temp at ambient 23
o
C:
- On flat surface, receiving, no air
34
o
C (11
o
over ambient)