User's Manual

P330 Data Sheet / User Guide 35
DRAFT
Shown in Figures 5-2 and 5-3 are all of the parts which extend out beyond the board dimensions.
This includes the RF SMA connectors, the Locking connector, the USB micro connectors, and the
RJ45 jack.
Fig. 5-3: Components which limit vertical height
When the P330 is mounted on a carrier board, the designer should be careful not to place any
components within 0.125” (3.17 mm) of the bottom of the board. This is a keep-out area and it is
reserved for components on the bottom side of the P330 board. Note that mating parts for the
mezzanine connectors are available with different lengths. By selecting a suitably tall mating
connector, the user can accommodate a wide variety of parts under the P330 without compromising
the keep-out area.
Fig. 5-4 Locations and dimensions of Power and I/O connectors at the rear of the P330
Fig. 5-5: Location and dimensions of RF SMA connector