Manual

GB - 3PI_FFA1210_Art0017978_1v2 126301-02
TCS TürControlSysteme AG
Geschwister-Scholl-Straße 7 • D-39307 Genthin
extent
TM
7.2 Window contact and window handle
Notes:
– The assignment and programming of a window contact
is also possible before the installation.
– Control of the radio actuator with window contacts and
window handles (beginning with Version 1.1).
7.2.1 Function 8 (Switch on/off)
7.2.2 Function 9 (Switch off/on)
Learn mode
• Assign/delete window contact with its program button.
• Assign/delete window handle by opening / closing.
Function programming (radio sensor detection)
• Activate the window contact once with the magnet.
• Open or close the window handle once.
Function setting (e.g. function 8)
LRN/SET button 8 x activated
LED blinks 8 x orange  function 3
Parameter setting (e.g. parameter 2)
LRN/SET button 2 x activated
LED blinks 2 x green  parameter 2
Window contact, window handle Function
Window contact or handle – opened Switch on
All window contacts and handles – closed Switch off
Parameter
1 Window contact function
2 Window handle function
Magnet
max. 5mm
8. Troubleshooting & remedies
8.1 New system or existing system
• Check power supply (electrician only).
• Check connected electrical loads.
• Check the system’s surroundings for changes that could
cause interference (e.g. metal cabinets, furniture or walls
which have been moved).
• If the radio sensor/radio actuator operates at a reduced
distance, the radio signal was encountering interference
or it was operating outside the transmission range.
• Use the radio actuator at a better location.
• Delete all radio sensors and reprogram the radio actuator.
8.2 Radio actuator switches by itself
• This may be caused by operation of an external sensor
that was coincidentally assigned to the radio actuator.
• Delete all radio sensors and reprogram the radio actuator.
8.3 Radio signal range limitations
• Use of the radio actuator in the vicinity of metal objects
or materials with metal components. Maintain a distance
of at least 10 cm.
• Moist materials.
• Devices which emit high-frequency signals (e.g. audio
and video systems, computers, electronic ballasts in light
xtures). Maintain a distance of at least 0.5 m.
8.4 Contact
Telephone:................ +49 (0)3933 - 8799 10
Fax:.......................... +49 (0)3933 - 8799 11
Internet:.................... www.tcs-germany.com
E-mail:...................... [e-mail]
9. Conformity declaration
TCS products may be sold and operated in EU countries
as well as in CH, IS and N. TCS herewith declares that
the radio actuator (FFA1210) is in compliance with the
fundamental requirements and other relevant provisions of
R&TTE Directive 1999/5/EC. The conformity declaration is
available on the Internet at the following address:
www.tcs-germany.com.
Window contact, window handle Function
Window contact or handle – opened Switch off
All window contacts and handles – closed Switch on
Parameter
1 Window contact function
2 Window handle function