Installation Guide

Once this process
is complete, you can use the remote control as discuss
Connecting a New or Pre-existing
Remote Control to the Gateway
The remote control in your lighting kit is already connected to your Gateway by default, so it is ready to use after
you prepare it as discussed above. However,
connect a remote control to your Gateway:
•
If you are adding a new remote control to your network
•
If you are upgrading your lighting network from a remote control kit and would like to use the o
remote control with your new network
•
If you performed a factory reset on your remote control and need to re
To physically connect a new or pre-
existing remote control to the Gateway:
1.
Make sure your remote control is in range
from the back of the remote control so that you have access to the
2. On the Gateway
, press the sync button once. The activity indicator begins to display
a clockwise rotating pattern.
3. On the remote control,
press and hold
4. While pressing the Program
button, press the
5. Release the Program button.
The primary
control connects with the Gateway
is complete, you can use the remote control as discuss
ed in the rest of this chapter.
Remote Control to the Gateway
The remote control in your lighting kit is already connected to your Gateway by default, so it is ready to use after
you prepare it as discussed above. However,
there are a few situations in which you would have to manually
connect a remote control to your Gateway:
If you are adding a new remote control to your network
If you are upgrading your lighting network from a remote control kit and would like to use the o
remote control with your new network
If you performed a factory reset on your remote control and need to re
-
connect it to the
existing remote control to the Gateway:
Make sure your remote control is in range
of the Gateway. Remove the battery cover
from the back of the remote control so that you have access to the
Program button.
, press the sync button once. The activity indicator begins to display
press and hold
the Program button.
button, press the
1-4 button three times consecutively.
The primary
indicator
light on the remote control flashes while the remote
control connects with the Gateway
. When this process is complete, the indicator
light will remain on for
ed in the rest of this chapter.
The remote control in your lighting kit is already connected to your Gateway by default, so it is ready to use after
there are a few situations in which you would have to manually
If you are upgrading your lighting network from a remote control kit and would like to use the o
ld
connect it to the
Gateway
light on the remote control flashes while the remote
light will remain on for