Installation Guide

Mounting the Gateway on a Wall
You can mount the Gateway to a wall with screws, using the mounting slots located on the back of the Gateway.
As shown in the illustration, you should use two self
(also refer to the correspon
ding illustration callouts):
1. 5.3 mm
2. 15 mm
3. M3
Screw the self-tapping screws
into the wall, level with a
distance of 60 m
m between the center point of the two
screw heads
. Hang the Gateway by sliding the holes
on the back of the unit over the screws and
pressing the Gateway downward until it is secure.
You can mount the Gateway to a wall with screws, using the mounting slots located on the back of the Gateway.
As shown in the illustration, you should use two self
-
tapping screws for mounting with the following dimensions
ding illustration callouts):
into the wall, level with a
m between the center point of the two
. Hang the Gateway by sliding the holes
on the back of the unit over the screws and
then gently
pressing the Gateway downward until it is secure.
You can mount the Gateway to a wall with screws, using the mounting slots located on the back of the Gateway.
tapping screws for mounting with the following dimensions