MSDS

MD TECHNOLOGY LIMITED
3
7. Ingredients EXPOSURE LIMITS QUANTITY
8. PHYSICAL PROPERTIES
9. SPILL MANAGEMENT PROCEDURES
10. DISPOSAL INFORMATION
11. PRECAUTIONS AND COMMENTS
Cadmium(as Cadmium,
Cadmium Hydroxide, 5 mog/m
3
dust – OSHA ≈17%
and Cadmium Oxide)
Nickel(as Nickel,
Nickel Hydroxide, 1mg/ m
3
-OSHA ≈19%
and Nickel Oxide)
KOH 2mg/ m
3
ACGIH Ceiling Air ≈1%
Cobalt Hydroxide
(as Cobalt Metal) 0.1mg/ m
3
dust – OSHA ≈1%
Boiling Point: Not applicable Melting pointing: Not applicable
Vapor Pressure: Not applicable Vapor Density: Not applicable
Specific Gravity: 1.17-1.250(electrolyte) Evaporation Rate: Not determined
Solubility in water: Electrolyte solution is completely soluble
REMAINDER: INSOLUBLE
Electrolyte Spill: Flush with water and neutralize with dilute vitriol.
Battery is TCLP Toxic. Battery and electrolyte solution are corrosive. If not recycled,
must be disposed of in accordance with all international, national, provincial
regulations.
These cells and batteries manufactured from them may be highly charged and are
capable of high-energy discharge. Care should be taken to handle cells properly to
avoid shorting or misuse that will result in rapid uncontrolled electrical, chemical, or
heat energy release.
Do not short circuit---may cause burns.
Do not break open cell.
Do not allow an exposed flame or spark to come near the cells.