User's Manual
Table Of Contents
- Package Contents
- Controls & Connections
- First-time Setup
- Using the Remote
- Proper Placement
- Mode & Level Settings
- Using Button Combinations
- Programming the Sound Bar
- Bluetooth Pairing
- Using Bluetooth Mode
- Connecting to a Voice Assistant
- Advanced Setup
- Connecting with HDMI ARC
- Connecting a Subwoofer
- Wall-mounting
- Product Registration and Support
- Help & Troubleshooting
- Limited Warranty
- Legal & Compliance
- Specifications
ENG - 9
After turning on both your TV and sound bar, it will automatically begin searching for an active input.
*
The LED indicator on the front of the sound bar will begin cycling in different colors through inputs
until an audio source is detected.
**
You can press the INPUT button to switch between audio
sources. For example, if you connected your TV to HDMI (ARC),
set the sound bar to HDMI-ARC.
6
Remove the battery cover by gently
sliding it away from the remote.
7
Insert the included batteries and gently
slide the battery cover back into place.
8
To p To p
Input
Power
*Occurs only during ๎rst-time set up.
**Auto detect function only occurs once when the sound bar is ๎rst powered on. To enable this feature
again, you must do a Factory Reset (see the Using Button Combinations on page 14 for more
information) or press and hold the INPUT button for 4 seconds.
When needed, VIZIO recommends replacing the batteries that came with
this remote with two, new Duracell โAAAโ alkaline batteries.
First-time Setup
Tip: Pressing the INPUT button will stop the auto
detect function.