User's Manual Part 2

29
VQT3V18
I can’t connect to the network.
¾ Confirm the network connection and settings.
(> 9, 11, 24)
¾ Check the operating instructions for each
device and connect accordingly.
When using Wireless LAN connection, video
from the DLNA Certified media server is not
played back or video frames are dropped
during playback.
¾ Higher transfer rate router such as 802.11n
(2.4 GHz) Wireless router may solve the
problem. If you use 802.11n (2.4 GHz)
Wireless router, it is necessary to set the
encryption type to “AES”.
Simultaneous use with a microwave, cordless
telephone etc. at 2.4 GHz may result in
connection interruptions or other problems.
¾ On the “Wireless Settings” screen (> 24), the
continuous lighting of at least 4 “Reception”
indicators is the target for a stable connection.
If 3 or fewer indicators are lit or the
connection is being interrupted, change the
position or angle of your Wireless router and
see if the connection state improves. If there
is no improvement, connect to a wired
network and perform the “Network Easy
Setting” (> 11) again.
Messages
The following messages or service numbers appear
on the television or unit’s display when something
unusual is detected.
Cannot play.
¾ You inserted an incompatible disc (Discs
recorded in PAL video, etc.).
Cannot display on this unit.
¾ You tried to play a non-compatible image.
No disc is inserted.
¾ The disc may be upside down.
$ This operation is not available.
¾ Some operations are unsupported by the unit.
For example;
– BD-Video: During playback, reverse
slow-motion or reverse frame-by-frame is not
possible.
IP address is not set.
¾ The “IP Address” in “IP Address/DNS
Settings” is “---. ---. ---. ---”. Set the “IP
Address”, “Subnet Mask”, and “Default
Gateway”. (Select the automatic address
acquisition if necessary.)
The current settings only offer minimal
wireless access point security and low
performance. It is recommended to change it
for better security.
¾ Authentication type for the Wireless LAN is
set to “Open system”, or the encryption type
is set to “No encryption”. It is recommended
to encrypt for safety reasons. For details,
refer to the instructions of the Wireless router
being used. Encryption is required when
playing back video, etc., from DLNA
compatible devices.
Network
On the television
Settings
DMP-BD87_77_VQT3V18_eng.book 29 ページ ２０１１年１０月２４日 月曜日 午後２時４５分