User's Manual Part 2

30
VQT3V18
F99
¾ The unit fails to operate properly. Press
[POWER Í/I] on the main unit for 3 seconds
to switch the unit to standby, then switch back
on.
HDMI ONLY
¾ Some BD-Video discs can only be output with
HDMI.
NET
¾ While connecting to a network.
No PLAY
¾ There is a viewing restriction on a BD-Video
or DVD-Video. (> 25)
No READ
¾ The media is dirty or badly scratched. The
unit cannot play.
PLEASE WAIT
¾ The unit is carrying out an internal process.
This is not a malfunction. You cannot operate
the unit while “PLEASE WAIT” is displayed.
REMOVE
¾ The USB device is drawing too much power.
Remove the USB device.
SET  (“  ” stands for a number.)
¾ The remote control and main unit are using
different codes. Change the code on the
remote control.
Press and hold [OK] and the
indicated number button at
the same time for more than
5 seconds.
U59
¾ The unit is hot.
The unit switches to standby for safety
reasons. Wait for about 30 minutes until the
message disappears.
Select a position with good ventilation when
installing the unit. Do not block the ventilation
hole on the side of the unit.
H or F
(“  ” stands for a number.)
¾ There is something unusual.
¾ Check the unit using the troubleshooting
guide. If the service number remains
displayed, do the following.
1 Disconnect the plug from the AC outlet, wait a
few seconds, then reconnect it.
2 Press [POWER Í/I] to turn the power on.
If the service number remains displayed despite
doing the above, request service from the dealer.
Inform the dealer of the service number when
requesting service.
START
¾ The system is being restarted during the
firmware update. Please do not turn off the
unit.
UPD/
(“  ” stands for a number.)
¾ The firmware is being updated.
Please do not turn off the unit.
FINISH
¾ The firmware update is complete.
On the unit’s display
DMP-BD87_77_VQT3V18_eng.book 30 ページ ２０１１年１０月２４日 月曜日 午後２時４５分