User's Manual

Use of the Magnetic strips
Magnetic strips (virtual walls) can be used to isolate areas that do not
want to be cleaned (such as toilets with wet floors or places where the
robotic vacuum cleaner may be stuck). When the robotic vacuum
cleaner is not expected to enter the cleaning area, tile the magnetic
strips along the entrance.
Please crop the magnetic stripe correctly, as shown in the picture.
Please use double-sided tape to fix the tape on the ground to
prevent it from falling off, otherwise the effect of the magnetic strip will
be affected.
* Please place the magnetic strip on the same plane where the robotic vacuum cleaner is
running.
magnetic strip
* Do not use the mopping mode on the carpet.
* When the robotic vacuum cleaner is in the charging state or idle,
remove the mop holder, and the water level can not be set in the
APP at this time.
* To achieve better mopping, it is recommended to use the main
machine to clean the floor three times before installing the mopping
module.
* To avoid damaging the wooden floor, please make sure to take out
the mopping assembly immediately after the main machine finishes
mopping.
* When the mopping is suspended or ends, the main machine will
automatically cut off the water, but the mop is still wet, and it should
not be placed in the same place for too long, and needs to be
handled in time.