User's Manual

Use of the mopping assembly
• Installation of the wet mopping assembly
Take out the two-in-one dust box and water tank assembly
Take out the dust box
Open the rubber plug and add water to the water tank from the
water injection port.
Install the mop on the mop holder.
After drying the water spilled or attached to the surface, put the
two-in-one dust box and water tank assembly back into the machine,
and make sure it is installed in place.
• Wet mopping settings
You can start cleaning by selecting the cleaning mode, and you can
select the water mopping level in the APP according to your needs.
* When mopping the floor, in order to prevent the robotic vacuum cleaner from wetting the
carpet, it is recommended to place a virtual wall magnetic stripe in the carpet area to protect
the carpet.
• Notice
* It is recommended to remove the mop holder after each use of the
mopping assembly, empty the water tank, wash the mop with water,
and air dry to avoid mold or odor.
take out the assembly
add water to the water tank
install the mop
install the
mop holder
intall the assembly
remove the assembly emply the water tank
take out the mop clean the mop
Sun-dry the mop
and holder