Safety Tips

4039
Although the SAR is determined at the highest
certified power level, the actual SAR level of the
mobile phone while operating can be well below the
maximum value. This is because the mobile phone
is designed to operate at multiple power levels
so as to use only the power required to reach the
network. In general, the closer you are to a wireless
base station antenna, the lower the power output
of the mobile phone. Before a mobile phone model
is available for sale to the public, compliance with
national regulations and standards must be shown.
The highest SAR value for this model mobile phone
when tested is 0.53 W/Kg for use at the ear and 1.43
W/Kg for use close to the body.
While there may be differences between the SAR
levels of various mobile phones and at various
positions, they all meet the government requirement
for RF exposure. For body-worn operation, the phone
has been tested when positioned a minimum of 15
mm from the body without any metal parts in the
vicinity of the phone or when properly used with an
appropriate accessory and worn on the body. Use
of other accessories may not ensure compliance
with FCC RF exposure guidelines. Additional
information on SAR can be found on the Cellular
Telecommunications & Internet Association (CTIA)
Web site: http://www.phonefacts.net
The World Health Organization (WHO) considers
that present scientific information does not indicate
the need for any special precautions for use of
mobile phones. If individuals are concerned, they
might choose to limit their own or their children’s
RF exposure by limiting the length of calls, or
using “hands-free” devices to keep mobile phones
away from the head and body. (fact sheet n°193).
Additional WHO information about electromagnetic
fields and public health are available on the following
website: http://www.who.int/peh-emf.
Note: This equipment has been tested and found
to comply with the limits for a Class B digital device
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.