Users Manual

5
Radio waves �����������������������������
THIS PHONE MEETS THE GOVERNMENT’S REQUIREMENTS
FOR EXPOSURE TO RADIO WAVES.
Your phone is a radio transmitter and receiver. It is designed
and manufactured not to exceed the emission limits for
exposure to radio-frequency (RF) energy. These limits are part
of comprehensive guidelines and establish permitted levels of
RF energy for the general population. The guidelines are based
on standards that were developed by independent scientific
organizations through periodic and thorough evaluation of
scientific studies. These guidelines include a substantial safety
margin designed to ensure the safety of all persons, regardless
of age and health.
The exposure standard for phones employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit
set by public authorities such as the Federal Communications
Commission of the US Government (FCC), or by Innovation,
Science and Economic Development Canada (ISEDC), is 1.6
W/kg averaged over 1 gram of body tissue. Tests for SAR are
conducted using standard operating positions with the phone
transmitting at its highest certified power level in all tested
frequency bands.
This device is complied with SAR for general population /
uncontrolled exposure limits in ANSI/IEEE C95.1-1992 and had
been tested in accordance with the measurement methods and
procedures specified in IEEE1528.
The FCC has granted an Equipment Authorization for this model
phone with all reported SAR levels evaluated as in compliance
with the FCC RF exposure guidelines. SAR information on this
model phone is on file with the FCC and can be found under the
Display Grant section of www.fcc.gov/oet/ea/fccid after searching
on FCC ID : 2ACCJH134
Although the SAR is determined at the highest certified power
level, the actual SAR level of the phone while operating can be
well below the maximum value. This is because the phone is
designed to operate at multiple power levels so as to use only
the power required to reach the network. In general, the closer
you are to a wireless base station antenna, the lower the power
output of the phone. Before a phone model is available for sale
to the public, compliance with national regulations and standards
must be shown.
The highest SAR value for this model phone when tested is
0.90 W/Kg for use at the ear and 1.35 W/Kg for use close to
the body.
While there may be differences between the SAR levels of various
phones and at various positions, they all meet the government
requirement for RF exposure.