Users Manual

EN-5
Radio waves �����������������������������
THIS DEVICE MEETS THE GOVERNMENT’S REQUIREMENTS
FOR EXPOSURE TO RADIO WAVES.
Your device is a radio transmitter and receiver. It is designed
and manufactured not to exceed the emission limits for
exposure to radio-frequency (RF) energy. These limits are part
of comprehensive guidelines and establish permitted levels of
RF energy for the general population. The guidelines are based
on standards that were developed by independent scientific
organizations through periodic and thorough evaluation of
scientific studies. These guidelines include a substantial safety
margin designed to ensure the safety of all persons, regardless
of age and health.
The exposure standard for devices employs a unit of
measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by public authorities such as the Federal
Communications Commission of the US Government (FCC),
or by Innovation, Science and Economic Development Canada
(ISED), is 1.6 W/kg averaged over 1 gram of body tissue. Tests
for SAR are conducted using standard operating positions with
the device transmitting at its highest certified power level in all
tested frequency bands.
This device is complied with SAR for general population /
uncontrolled exposure limits in ANSI/IEEE C95.1-1992 and had
been tested in accordance with the measurement methods and
procedures specified in IEEE1528.
The FCC has granted an Equipment Authorization for this model
device with all reported SAR levels evaluated as in compliance
with the FCC RF exposure guidelines. SAR information on this
model device is on file with the FCC and can be found under the
Display Grant section of www.fcc.gov/oet/ea/fccid after searching
on FCC ID: 2ACCJB153
Although the SAR is determined at the highest certified power
level, the actual SAR level of the device while operating can be
well below the maximum value. This is because the device is
designed to operate at multiple power levels so as to use only
the power required to reach the network. In general, the closer
you are to a wireless base station antenna, the lower the power
output of the device. Before a device model is available for sale
to the public, compliance with national regulations and standards
must be shown.
The highest SAR value for this model 8092 when tested is 1.28
W/Kg for use close to the body.
While there may be differences between the SAR levels of various
devices and at various positions, they all meet the government
requirement for RF exposure.