User Guide
Table Of Contents
- Getting to Know Your Mobile Hotspot
- LED Description
- Indicators
- Inserting the SIM card
- Removing the SIM card
- Inserting/Removing the battery
- Charging Your Mobile Hotspot
- Charging other devices
- Forgot your password?
- OS supported
- Connect your Wi-Fi device to your Mobile Hotspot
- Use the WPS
- Managing Your Mobile Hotspot
- Accessing Your Mobile Hotspot
- Access Using a USB Cable
- Change Mobile Hotspot Admin Password
- Change Mobile Hotspot Network Name (SSID)
- Change Mobile Hotspot Wi-Fi Password
- How to use the Mobile Hotspot Whitelist Function
- Updating Your Software Version
- Safety and Use
- Conditions of use
- Radio Waves
- Licenses
- General Information
- 12 Month Limited Warranty
- Electronic Information
21 22
Chargers:
Home A.C./ travel chargers will operate within the
temperature range of: 0°C (32°F) to 40°C (104°F).
Chargers designed for your mobile hotspot meet
the standard for safety of information technology
equipment and office equipment use. Due to different
applicable electrical specifications, a charger that
you purchased in one region may not work in another
region. They should be used for this purpose only.
Specifications of power supply (depending on the country):
Travel charger: Input: 100-240 V, 50/60 Hz, 0.5A
Output: 5V, 2A
Battery: 3.7 V Li-ion Battery
Typical Capacity: 4400 mAh
RADIO WAVES
THIS DEVICE MEETS GOVERNMENT REQUIREMENTS
FOR EXPOSURE TO RADIO WAVES.
Your router is a radio transmitter and receiver. It is designed
and manufactured not to exceed the emission limits for
exposure to radiofrequency (RF) energy. These limits are
part of comprehensive guidelines and establish permitted
levels of RF energy for the general population. The
guidelines are based on standards that were developed by
independent scientific organizations through periodic and
thorough evaluation of scientific studies. These guidelines
include a substantial safety margin designed to ensure the
safety of all persons, regardless of age and health.
The exposure standard for routers employs a unit of
measurement known as the Specific Absorption Rate,
or SAR. The SAR limit set by public authorities such as
the Federal Communications Commission of the US
Government (FCC), or by Industry Canada, is 1.6 W/kg
averaged over 1 gram of body tissue. Tests for SAR are
conducted using standard operating positions with the
router transmitting at its highest certified power level in
all tested frequency bands.
Although the SAR is determined at the highest certified
power level, the actual SAR level of the router while
operating can be well below the maximum value. This
is because the router is designed to operate at multiple
power levels so as to use only the power required to
reach the network. In general, the closer you are to
a wireless base station antenna, the lower the power
output of the router. Before a router model is available
for sale to the public, compliance with national
regulations and standards must be shown.
The highest SAR value for this model router when
tested is 0.97 W/Kg for use close to the body.
While there may be differences between the SAR
levels of various routers and at various positions, they
all meet the government requirement for RF exposure.
For body-worn operation, the router meets FCC RF
exposure guidelines provided that it is used with a non-
metallic accessory with the handset at least 10 mm
from the body. Use of other accessories may not ensure
compliance with FCC RF exposure guidelines.