User's Guide

IK41 4G USB Dongle
Safety and Warranty Informaon
CQF1PT5ALAAA
www.sar-ck.com
This product meets applicable naonal SAR limits
of 1.6W/kg.
The specic maximum SAR values can be found in
the secon of this user guide.
When carrying the product or using it while worn
on your body, either use an approved accessory
such as a holster or otherwise maintain a distance
of 5 mm from the body to ensure compliance with
RF exposure requirements.
Note that the product may be transming even if
you are not browsing the Internet.
Warning and Precauons
Electronic Device
Turn o your device near high-precision
electronic devices. The wireless device may
aect the performance of these devices. Such
devices include hearing aids, pacemakers,
re alarm system, automac gates, and other
automac devices. If you are using an electronic
medical device, consult the device manufacturer
to conrm whether the radio wave aects the
operaon of this device.
Hospital
Pay aenon to the following points in hospitals
or health care facilies:
• Do not take your wireless device into the
operang room, intensive care unit, or coronary
care unit.
• Do not use your wireless device at places for
medical treatment where wireless device use is
prohibited.
Storage Environment
• Do not place magnec storage media such
as magnec cards and oppy disks near the
wireless device. Radiaon from the wireless
device may erase the informaon stored on
them.
• Do not put your wireless device and other
accessories in containers with a strong
magnec eld, such as an inducon cooker or
microwave oven to avoid circuit failure, re, or
explosion.
• Do not leave your wireless device in a very
hot or cold place to avoid malfuncon of the
product, re, or explosion.
• Do not subject your wireless device to serious
collision or shock to avoid wireless device
malfuncon, overheang, re, or explosion.
Child Safety
• Put your wireless device in places beyond the
reach of children. Do not allow children to use
the wireless device without supervision.
• Do not allow children to put the device in their
mouth.
• Do not allow children to touch the small ngs
to avoid suocang or choking caused from
swallowing the ngs.
Operang Environment
• The wireless device is not water-resistant. Keep
it dry. Protect the wireless device from water
or vapor. Do not touch the wireless device
with a wet hand. Otherwise, short-circuit and
malfuncon of the product or electric shock
may occur.
• Do not use the wireless device in dusty, damp
and dirty places or places with magnec elds.
• Do not use your device outdoors during a
thunderstorm.
• The wireless device may interfere with nearby
TV sets, radios and PCs.
• In accordance with internaonal standards
for radio frequency and radiaon, use
wireless device accessories approved by the
manufacturer only.
Trac Safety
Do not use the device while driving.
• When switched on, this device emits
electromagnec waves that can interfere with
the vehicle’s electronic systems such as ABS
an-lock brakes or airbags. To ensure that there
is no problem, do not place this device on top of
the dashboard or within an airbag deployment
area.
• Check with your car dealer or the car
manufacturer to make sure that the dashboard
is adequately shielded from this device’s RF
energy.
Condions of Use
• Switch this device o before boarding an
aircra.
• Switch this device o when you are in health
care facilies, except in designated areas. As
with many other types of equipment now in
regular use, this device can interfere with other
electrical or electronic devices, or equipment
using radio frequencies.
• Switch this device o when you are near gas
or ammable liquids. Strictly obey all signs
and instrucons posted in a fuel depot, petrol
staon, chemical plant, or in any potenally
explosive atmosphere.
• When this device is switched on, it should be
kept at least 15 cm from any medical device
such as a pacemaker, hearing aid, insulin pump,
etc.
• Do not let children use this device without
supervision.
• When replacing the cover, please note that
this device may contain substances that could
create an allergic reacon.
• Always handle this device with care and keep it
in a clean and dust-free place.
• Do not open, dismantle or aempt to repair this
device yourself.
• Do not drop, throw or bend this device.
• Do not paint it.
WEEE Approval
This device is in compliance with the essenal
requirements and other relevant provisions of the
Waste Electrical and Electronic Equipment
Direcve 2012/19/EU (WEEE Direcve)
This symbol on this device means
that these products must be taken
to collecon points at the end of
their life:
- Municipal waste disposal centers
with specic bins for these types of
equipment.
- Collecon bins at points of sale.
They will then be recycled, so that their
components can be reused, and to prevent
substances being disposed of in the environment.
In European Union countries:
These collecon points are accessible free of
charge.
All products with this symbol must be brought to
these collecon points.
In non-European Union jurisdicons:
Items of equipment with this symbol are not to
be thrown into ordinary bins if your jurisdicon or
your region has suitable recycling and collecon
facilies; instead they are to be taken to collecon
points for recycling.
RoHs Approval
This device is in compliance with the restricon
of the use of certain hazardous substances in
electrical and electronic equipment Direcve
2011/65/EU (RoHs Direcve).
• Federal Communicaons Commission (FCC)
Declaraon of Conformity
This device complies with part 15 of the FCC
Rules. Operaon is subject to the following two
condions: (1) This device may notcause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesiredoperaon.
Changes or modicaons not expressly approved
by the party responsible for compliance could void
the user‘s authority to operate the equipment.
This device has been tested and found to comply
with the limits for a Class B digital, pursuant
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protecon
against harmful interference in a residenal
installaon. This equipment generates, uses
and can radiated radio frequency energy and,
if not installed and used in accordance with the
instrucons, may cause harmful interference
to radio communicaons. However, there is no
guarantee that interference will not occur in a
parcular installaon If this equipment does
cause harmful interference to radio or television
recepon, which can be determined by turning
the equipment o and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separaon between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit dierent from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
FCC Cauon:
Changes or modicaons not expressly approved
by the party responsible for compliance could void
the user‘s authority to operate the equipment.
FCC RF Exposure Informaon (SAR):
This device is designed and manufactured not
to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal
Communicaons Commission of the United
States.
During SAR tesng, this is set to transmit at
its highest cered power level in all tested
frequency bands, and placed in posions that
simulate RF exposure in usage near the body
with the separaon of 9 mm. Although the SAR
is determined at the highest cered power level,
the actual SAR level of the device while operang
can be well below the maximum value. This is
because the device is designed to operate at
mulple power levels so as to use only the power
required to reach the network. In general, the
closer you are to a wireless base staon antenna,
the lower the power output.
The exposure standard for wireless is employs
a unit of measurement known as the Specic
Absorpon Rate, or SAR. The SAR limit set by the
FCC is 1.6 W/kg.
Tests for SAR are conducted using standard
operang posions accepted by the FCC with the
device transming at its highest cered power
level in all tested frequency bands.
The FCC has granted an Equipment Authorizaon
for this model device with all reported SAR levels
evaluated as in compliance with the FCC RF
exposure guidelines. SAR informaon on this
model device is on le with the FCC and can
be found under the Display Grant secon of
HYPERLINK “hp://www.fcc.gov/oet/ea/fccid”
www.fcc.gov/oet/ea/fccid aer searching on FCC
ID: 2ACCJB115.
The highest SAR value for this model phone when
tested is 1.39 W/Kg for use close to the body.
SAR compliance for body operaon is based on a
separaon distance of 9 mm between the device
and the human body. During use, the actual SAR
values for this device are usually well below the
values stated above. This is because, for purposes
of system eciency and to minimize interference
on the network, the operang power of your
device is automacally decreased when full
power is not needed. The lower the power output
of the device, the lower its SAR value.
Body-worn SAR tesng has been carried out
at a separaon distance of 9 mm. To meet RF
exposure guidelines during body-worn operaon,
the device should be posioned at least this
distance away from the body.
If you are not using an approved accessory ensure
that whatever product is used is free of any metal
and that it posions the device the indicated
distance away from the body.
Organizaons such as the World Health
Organizaon and the US Food and Drug
Administraon have suggested that if people are
concerned and want to reduce their exposure
they could use a hands-free accessory to keep
the wireless device away from the head or body
during use, or reduce the amount of me spent
on the device.
IC Noce
This device complies with Industry Canada
license-exempt RSS standard(s). Operaon is
subject to the following two condions:
(1) this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause undesired
operaon of the device.
This Class B digital apparatus complies with
Canadian ICES-003.
IC: 9238A-0099
IC Radiaon Exposure Statement
This EUT is compliance with SAR for general
populaon/uncontrolled exposure limits in IC
RSS-102 and had been tested in accordance
with the measurement methods and procedures
specied in IEEE 1528 and IEC 62209. This
equipment should be installed and operated with
minimum distance 0.9 cm between the radiator
and your body. This device and its antenna(s) must
not be co-located or operang in conjuncon
with any other antenna or transmier.
General informaon
Website for USA: us.alcatelmobile.com
Website for Canada: ca.alcatelmobile.com
Hotline: In the United States, call 855-368-0829
for technical support, In Canada, please call 855-
844-6058.
Manufacturer: TCL Communicaon Ltd.
Address: 5/F, Building 22E, 22 Science Park East
Avenue, Hong Kong Science Park, Shan, NT,
Hong Kong.
Your device is a transceiver that operates on
GSM in quad-band (850/900/1800/1900
MHz), UMTS/HSDPA/HSDPA+ in quad-
band Band 2/4/5 or LTE in hexa-band Band
2/4/5/7/12/13/17/71.
Disclaimer
There may be certain dierences between
the user manual descripon and the device’s
operaon, depending on the soware release
of your device or specic carrier services. TCL
Communicaon Ltd. shall not be held legally
responsible for such dierences, if any, nor for
their potenal consequences, which responsibility
shall be borne by the carrier exclusively.
Warranty
The device is warranted against any deviaon
from technical specicaons for a period of
twelve (12) months from the date specied on
your original invoice
(1)
.
Under the terms of this warranty, you must
immediately inform your vendor in case of a
conformity defect on this device, and present a
proof of purchase.
The vendor or repair center will decide whether to
replace or repair this device, as appropriate.
Repaired or replaced this device are warranted
ONE (1) month unless there are statutory
provisions to the contrary.
This warranty shall not apply to damage or
defects to this device due to:
1) Not following the instrucons for use or
installaon.
2) Not being compliant with technical and safety
standards applicable in the geographical area
where this device is used.
3) Improper maintenance of sources of energy,
and of the overall electric installaon.
4) Accidents or consequences of the of the
vehicle in which this device is transported,
acts of vandalism, lightning, re, humidity,
inltraon of liquids, inclement weather.
5) Connecng to or integrang into this device any
equipment not supplied or not recommended
by the manufacturer.
6) Any servicing, modicaon or repair
performed by individuals not authorized by
the manufacturer, the vendor or the approved
maintenance centre.
7) Use of this device for a purpose other than that
for which it was designed.
8) Malfuncons caused by external causes (e.g.,
radio interference from other equipment,
power voltage uctuaons).
9) Faulty connecons resulng from
unsasfactory radio transmission or caused by
the absence of radio relay coverage.
Warranty is also excluded for this device on which
markings or serial numbers have been removed
or altered.
This device is also warranted against hidden
defects (defects inherent in the design,
manufacture, etc.).
There are no other express warranes than this
printed limited warranty, expressed or implied, of
any nature whatsoever.
In no event shall the manufacturer be liable for
incidental or consequenal damages of any
nature whatsoever, including but not limited to
trading loss, commercial loss, to the full extent
those damages can be disclaimed by law. Some
countries/states do not allow the exclusion or
limitaon of incidental or consequenal damages,
or limitaon of the duraon of implied warranes,
so the preceding limitaons or exclusions may not
apply to you.
---------------------------------------------------------
(1)
The mandatory warranty period may vary if
overriding statutory provisions are applicable in
your jurisdicon.
Electronic Informaon
For more informaon on Electronic Recycling:
1) Visit Alcatel Electronic Recycling Program
website at
https://us.alcatelmobile.com/accessibility-
compliance/electronic-recycling-program/, or
2) Call Alcatel US Customer Support at 1-855-
368-0829.
Baery Recycling (USA & Canada):
Alcatel partners with Call2Recycle® to oer a
safe and convenient baery recycling program.
For more informaon on our Baery Recycling
Program, please visit the USA and
Canada website at hps://us.alcatelmobile.
com/accessibilitycompliance/batteryrecycling/
and hps://ca.alcatelmobile.com/accessibility-
compliance/baeryrecycling/.