Safety Manual
• Do not expose your device or its accessories
to extreme temperatures, minimum –10 and
maximum +55 degrees Celsius.
• Do not use your device in an enclosed
environment or where heat dissipation is
poor. Prolonged use in such space may cause
excessive heat and raise ambient temperature,
which will lead to automatic shutdown of your
device or the disconnection of the mobile
network connection for your safety. To use your
device normally again after such shutdown,
cool it in a well-ventilated place before turning
it on.
• Please check local regulations for disposal of
electronic products.
• Do not carry your device in your back pocket as
it could break when you sit down.
• Do not operate the device where ventilation is
restricted - for example, do not operate inside
a jacket pocket, inside a handbag or in any
conned space.
Small Children
Do not leave your device and its accessories
within the reach of small children or allow them
to play with it.
They could hurt themselves or others, or could
accidentally damage the device.
Your device contains small parts with sharp edges
that may cause an injury or which could become
detached and create a choking hazard.
Air Bags
Do not place this device in the area over an air bag
or in the air bag deployment area. Store the device
safely before driving your vehicle.
Emergency Situations
This device, like any wireless device, operates
using radio signals, which cannot guarantee
connection in all conditions. Therefore, you
must never rely solely on any wireless device for
emergency communications.
Device Heating
Your device may become warm during charging
and during normal use.
WEEE Approval
The wireless device is approved to be used in
the member states of the EU. The manufacturer
declares that the wireless device is in compliance
with the essential requirements and other
relevant provisions of the Waste Electrical and
Electronic Equipment Directive 2012/19/EU
(WEEE Directive).
Electrical Safety
Accessories
Only use approved accessories.
Do not connect with incompatible products or
accessories.
This product is powered by USB port with output
voltage of 4.5~5.5Vdc and output current below
3A.
Connection to a Car
Seek professional advice when connecting a
device interface to the vehicle electrical system.
Faulty and Damaged Products
Do not attempt to disassemble the device or its
accessory.
Only qualied personnel must service or repair
the device or its accessory.
If your device or its accessory has been
submerged in water, punctured, or subjected to a
severe fall, do not use it until you have taken it to
be checked at an authorised service centre.
Interference
Care must be taken when using the device in close
proximity to personal medical devices, such as
pacemakers and hearing aids.
Pacemakers
Pacemaker manufacturers recommend that a
minimum separation of 15 cm be maintained
between a device and a pacemaker to avoid
potential interference with the pacemaker.
Hearing Aids
People with hearing aids or other cochlear
implants may experience interfering noises when
using wireless devices or when one is nearby.
The level of interference will depend on the
type of hearing device and the distance from the
interference source, increasing the separation
between them may reduce the interference. You
may also consult your hearing aid manufacturer
to discuss alternatives.
Medical devices
Please consult your doctor and the device
manufacturer to determine if operation of your
device may interfere with the operation of your
medical device.
Hospitals
Switch off your wireless device when requested to
do so in hospitals, clinics or health care facilities.
These requests are designed to prevent possible
interference with sensitive medical equipment.
Aircraft
Switch off your wireless device whenever you are
instructed to do so by airport or airline staff.
Consult the airline staff about the use of wireless
devices on board the aircraft. If your device offers
a ‘ight mode’ this must be enabled prior to
boarding an aircraft.
Interference in cars
Please note that because of possible interference
to electronic equipment, some vehicle
manufacturers forbid the use of devices in their
vehicles unless an external antenna is included in
the installation.
Explosive environments
Petrol stations and explosive atmospheres
In locations with potentially explosive
atmospheres, obey all posted signs to turn off
wireless devices such as your device or other radio
equipment.
Areas with potentially explosive atmospheres
include fuelling areas, below decks on boats, fuel
or chemical transfer or storage facilities, areas
where the air contains chemicals or particles, such
as grain, dust, or metal powders.
Blasting Caps and Areas
Turn off your device or wireless device when in a
blasting area or in areas posted turn off “two-way
radios” or “electronic devices” to avoid interfering
with blasting operations.
Frequency Bands and Power
(a) Frequency bands in which the radio equipment
operates: Some bands may not be available in all
countries or all areas. Please contact the local
carrier for more details.
(b) Maximum radio-frequency power transmitted
in the frequency bands in which the radio
equipment operates: The maximum power for all
bands is less than the highest limit value specied
in the related Harmonized Standard.
The frequency bands and transmitting power
(radiated and/or conducted) nominal limits
applicable to this radio equipment are as follows:
Max Transmitter power
IK41VE
GSM 900: 33.5 dBm
GSM 1800: 31 dBm
UMTS B1 (2100): 23 dBm
UMTS B8 (900): 23.5 dBm
LTE B1/7/8/20/28 (2100/2600/
900/800/700): 23.5 dBm
LTE B3 (1800): 23.8 dBm
IK41UD
GSM 900: 33.5 dBm
GSM 1800: 31 dBm
LTE B3 (1800): 23.8 dBm
LTE B7/28 (2600/700): 23.5 dBm
IK41US
GSM 900: 33.5 dBm
GSM 1800: 31 dBm
LTE B7 (2600): 23.5 dBm
IK41CQ
GSM 900: 33.5 dBm
GSM 1800: 31 dBm
UMTS B1 (2100): 23 dBm
LTE B1/28/40 (2100/700/ 2300):
23.5dBm
LTE B3 (1800): 23.8 dBm
Software Information
The product software version is IK41_00_02.00_06
or later. Software updates will be released to
enhance usability of the product.
For the most recent information about software,
please see the DoC (Declaration of Conformity)
at www.vodafone.com/business/iot/iot-devices/
integrated-terminals.
Software Update
By continuing to use this device, you indicate that
you have read and agree to the following content:
In order to provide better service, this device will
automatically obtain software update information
from Vodafone or our suppliers after connecting
to the Internet.
This process will use mobile data, and requires
access to your device’s unique identier (IMEI/
Serial Number) and the service provider network
ID (PLMN) to check whether your device needs to
be updated.
In addition, this device supports the automatic
downloading and installation of important
updates from Vodafone or our suppliers e.g. to
provide security updates.
CQF1PT0VDAAA