User's Manual

25 26
properly used with an appropriate accessory and worn on the body.
Use of other accessories may not ensure compliance with FCC RF
exposure guidelines. Additional information on SAR can be found
on the Cellular Telecommunications & Internet Association (CTIA)
Web site: https://www.ctia.org
The World Health Organization (WHO) considers that present
scientic information does not indicate the need for any special
precautions for use of mobile devices. If individuals are concerned,
they might choose to limit their own or their children’s RF
exposure by limiting the length of calls, or using “hands-free”
devices to keep mobile devices away from the head and body. (fact
sheet n°193). Additional WHO information about electromagnetic
elds and public health are available on the following website: http://
www.who.int/peh-emf.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
• Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
The exposure standard for mobile devices employs a unit of
measurement known as the Specic Absorption Rate, or SAR.
The SAR limit set by public authorities such as the Federal
Communications Commission of the US Government (FCC), or by
Industry Canada, is 1.6 W/kg averaged over 1 gram of body tissue.
Tests for SAR are conducted using standard operating positions with
the mobile device transmitting at its highest certied power level in
all tested frequency bands.
The FCC has granted an Equipment Authorization for this model
device with all reported SAR levels evaluated as in compliance with
the FCC RF exposure guidelines. SAR information on this model
device is on file with the FCC and can be found under the Display
Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC
ID: 2ACCJB111.
E-labeling: To find more information regarding FCC ID, IMEI number,
and more, go to Settings > System > Advanced > Regulatory &
Safety.
Although the SAR is determined at the highest certied power level,
the actual SAR level of the mobile device while operating can be
well below the maximum value. This is because the mobile device is
designed to operate at multiple power levels to use only the power
required to reach the network. In general, the closer you are to a
wireless base station antenna, the lower the power output of the
mobile device. Before a mobile device model is available for sale
to the public, compliance with national regulations and standards
must be shown. The highest SAR value for this model mobile phone
when tested is 0.87 W/Kg for use at the ear and 1.37 W/Kg for use
close to the body.
While there may be differences between the SAR levels of various
mobile devices and at various positions, they all meet the government
requirement for RF exposure. For body-worn operation, the device
has been tested when positioned a minimum of 15 mm from the
body without any metal parts in the vicinity of the device or when