User's Manual

Optional: Installing the external antennae
In areas with poor signal reception, connect external antennae to
the two ports labelled 'LTE' to improve signal reception.
Warning:
Before installing the external antennae, ensure that your Cat4
Router is powered off and disconnected from the power outlet.
The external antennae must be installed by a qualified technician.
Use antennae supplied by device manufacturer only.
5V2A
① Power off your Cat4
Router and disconnect it
from the power outlet.
② Open the 'LTE' covers
on both sides.
③ Screw external antennae
fully into the antennae port.
④ Keep external antennae
pointed upwards to get a
better signal.
Connect your device to the network
•WiFi
To establish a wireless network connection, follow the steps below;
Device supports 2.4 GHz and 5 GHz WiFi networks.
1) To make sure WiFi is enable, check to see if the WiFi LED on your
device is blue. (Refer to the section: Getting to know your device)
2) Turn on WiFi on the device you wish to connect. For help refer to
your laptop / device manual.
3) Search for the Wireless Network name on your laptop / device. The
network name or SSID can be found on the label on the back of the
device, along with your security / WiFi key.
XXXXXXXXX
4) Click connect and enter the security / WiFi key. You’ll now be connected
with Cat4 Router.
How to change WiFi Key
1) Enter http://192.168.1.1 in the address bar and press enter. The
Home page will then load.
2) Click Log in and enter the password (admin by default) .
Note: You will be forced to change the default password for
additional security.
3) Go to Settings > WiFi > Basic to change WiFi Key.
Safety reminder
• During thunderstorms, turn off the device and remove all cables.
• Do not use an external antenna or a power adapter that is not a
standard component for the device or is not Alcatel approved.
Alcatel is not liable for any problems that may result from use of
such an external antennae or power adapter. Outdoor antennas
must be installed by a qualified technician.
• The modem and SIM card are not compatible with any other
device.
Moving home?
Your Home Wireless Broadband service can move with you, just make
sure there’s coverage in your new location.
•Ethernet cable
Connect one end of the Ethernet cable into either of these two LAN
ports. The other end simply plugs into your device.(ie. Laptop or PC)
Up to two devices can be connected using the LAN ports.
5V2A
CJB1KA2ALAAA
Quick Start Guide