User's Manual

Although the SAR is determined at the highest certified

power level, the actual SAR level of the device while

operating can be well below the maximum value. This is

because the device is designed to operate at multiple power

levels so as to use only the power required to reach the

network. In general, the closer you are to a wireless base

station antenna, the lower the power output.

The exposure standard for wireless devices employs a unit

of measurement known as the Specific Absorption Rate, or

SAR. The SAR limit set by the FCC is 1.6W/kg.

Tests for SAR are conducted using standard operating

positions accepted by the FCC with the device transmitting

at its highest certified power level in all tested frequency

bands.

The FCC has granted an Equipment Authorization for

this model device with all reported SAR levels evaluated

as in compliance with the FCC RF exposure guidelines.

SAR information on this model device is on file with the

FCC and can be found under the Display Grant section

of HYPERLINK "http://www.fcc.gov/oet/ea/fccid" www.fcc.

gov/oet/ea/fccid after searching on FCC ID: 2ACCJB066

For this device, the highest reported SAR value for usage

near the body is:

Maximum SAR for this model and conditions under which

it was recorded:

9015B (Body) 1.36 W/kg

SAR compliance for body operation is based on a

separation distance of 0.9 cm between the device and

the human body. During use, the actual SAR values for

this device are usually well below the values stated above.

This is because, for purposes of system efficiency and to

minimize interference on the network, the operating power

of your device is automatically decreased when full power is

not needed. The lower the power output of the device, the

lower its SAR value.

Body SAR testing has been carried out at a separation

distance of 0.9 cm. To meet RF exposure guidelines during

body-worn operation, the device should be positioned at

least this distance away from the body.

If you are not using an approved accessory ensure that

whatever product is used is free of any metal and that it

positions the device the indicated distance away from the

body.