User's Manual
6
z WPA: A strong security standard, supported by most Wi-Fi devices.8 to 63 ASCII
characters needed.
z WPA2: A stronger, newer security standard. Limited to newer Wi-Fi devices. 8 to 63
ASCII characters needed.
¾ Login Settings: dene your login password
z Login password characters: 4-16, if exceeds 16 characters, not allow to proceed;
z If an invalid character is input, error message is displayed under user name, data not
saved:
z Password can contain letters, numbers, and symbols (ASCII characters 4-16), but not the
following: ” ; \ & % + ‘ < > ?
¾ Prole management: Edit your prole
¾ PIN Code Settings: PIN operation: include three behaviors Enable/Disable/Modify
Note:
1. When you entered wrong PIN 3 times, PUK is needed, you can get this key from the operator.
2. PIN code:4-8 digits.
¾ Connection mode: Automatic or Manual at draw down list;
¾ Network mode: Auto, 2G only, 3G only, 4G only modes in draw down list;
¾ Advanced Settings
z DHCP
Router IP Address: The router’s IP address on the LAN. The default setting is
“192.168.1.1”.
Subnet Mask: The router’s internal LAN subnet mask. The default setting is
“255.255.255.0”.
Host Name: Name of web server.
DHCP Server: DHCP Server will automatically assign IP addresses to devices on the
network. The default setting is “Enable”.
DHCP IP Pool: Set a range of IP addresses available to access.
DHCP Lease Time: Amount of time that a Wi-Fi enabled device can use its assigned IP
address before it is required to renew the lease.
z MAC Filter: MAC ltering is used to control specic MAC addresses to access, include
Disable, Allow, and Deny.
Note: The maximum allowed MAC list is 15
¾ About: Display your device basic information
z Reboot: Restart the device
z Reset: Reset the device to the original factory settings
6. More
¾ WPS
z WPS mode: PBC (default) Or WPS PIN, If choose PBC mode, PBC button and guide
reminder display;
z If choose WPS PIN, WPS PIN put in and guide reminder display. put in WPS pin then click
Save to nish setting