Bluetooth Headset User Guide
Catalog Specifications......................................................... 3 Overview............................................................... 4 Getting Started..................................................... 5 Using your headset.............................................. 6 LED Status........................................................... 11 Troubleshooting.................................................. 13 Safety Information..............................................
Specifications Bluetooth Specification BT BLE4.0, Class 2 Bluetooth profile details HFP v1.6 + HSP v1.2 + A2DP v1.2 Operating range About 10m Charging Time less than 1.5 hour Talk Time* Up to 5 hours Standby Time* Up to 168 hours (One week charge) Dimensions 60 x 12.3 x 6.30 mm Weight 7g Operating temperature range -20°C to 55°C Storage temperature range -30°C to 70°C * May vary due to the user’s habit, different modes of operation and mobile phone settings.
Overview 2 1 3 5 4 8 1. Power Key • Power on / off • Pair with mobile phone • Answer / End a call • Reject / Transfer a call • Stop / Play music 2. In-ear Rubber 3.
4. Volume Key • Volume increased / decreased • Previous / Next song • Setting language 5. USB Cap 6. Speaker 7. USB Pins • Charging battery 8. Microphone Getting Started To use BH60 Bluetooth headset, please follow the steps below: 1. Charging Your Headset Ensure your headset is fully charged and power on before using. The headset comes with a builtin rechargeable battery. It is recommended to fully charge prior to using the headset for the first time.
2. Pairing Pair your charged headset with a Bluetooth-enabled mobile phone. 1) Ensure that headset is off. 2) To activate the pairing mode, press and hold the headset’s Power Key without releasing your finger until its status indicator flashes red/blue. 3) Make sure that your mobile device’s Bluetooth is activated. Search Bluetooth devices and select “ALCATEL onetouch BH60” to connect. After paired, LED changed to blue and lighted one time every six seconds.
Pairing After power on, automatically switched to pairing status. Blue LED will light one time each second. Paired No necessary to input pin, after paired, LED changed to blue and lighted one time every six seconds. "Phone 1 connected" alarmed through in-ear headset. Volume + Long Press means to switch music song. Short Press means to adjust the volume of sound. "Maximum volume" alarmed if changed to maximum volume. Volume - Long Press means to switch music song.
Music Play At standby situation, press power key one time to play music and press again to stop. Long press volume upper key one time will change to previous song. Long press volume lower key one time will change to next song. Prompt language Press both volume upper and lower keys over 3 seconds, language prompts can be switched between English, Spanish, and Italian.
Power off Press power key more than three seconds after switch on, "Power off" alarmed through in-ear headset. Red LED will light three seconds constantly then power off. Low power If battery cell less than 10% power, red LED will light three times continuously every one minute and "Low power" alarmed through inear headset. Power symbol will change to blank one on mobile phone If battery cell less than 5% power, red LED will light three seconds c o n s t a n t ly.
Reject call Press power key button two times within three seconds or say "NO" to reject the call. Voice transfer At standby situation, press power key two times within three seconds and voice dialing function will be activated. Call transfer While speaking, long press and hold any volume key, a short beep and audio output will change to mobile phone. Charging battery Direct USB plug, constant red LED lighting, changed to constant blue LED lighting or no lighting once full charged.
LED Status Pattern Status Action Red Lighting Blue Lighting /. /. /. Pair Mode /. /. flashes frequency: one time each second (remain 120s at the pairing status) Connected Mode Just connect /. Keep connecting /. flashes slowly flashes frequency: one time per 6 second (Because of power cost) Reconnected Just disconnect /. Working Standby Mode Mode Keep /.
Pattern Status Action Power Power on long press flashes 5s; /. power button flash 3s frequency: one time each second Red Lighting Power off lighting 3s long press power button constantly 3s Charging Direct USB plug /. /. lighting constantly (after fully charged, turn off) Low battery battery flashes capacity is constantly; less than 10% flash frequency: three times per 1 min battery lighting 3s capacity is constantly less than 5% (After playing prompt voice, power off) 12 Blue Lighting /.
Troubleshooting I can hear crackling noise. To receive the best audio quality, it is recommended to wear your headset on the same side of the body as your mobile phone. I can't hear anything in my headset. • Ensure the headset is turned on and is properly charged. • Ensure the headset is properly paired with the mobile phone.
I can't connect my headset with my mobile phone. • Ensure your headset is turned off and is properly charged. • Ensure the headset is properly paired with your mobile phone. • Ensure your mobile phone’s Bluetooth feature is activated. Please refer to your mobile phone user guide for specific instruction. • Ensure the headset is within 32 feet range of your mobile phone and there are no obstructions, such as walls or other electronic devices in between.
Safety Information Check and observe local laws regarding the use of a mobile phone and a headset while driving. If you use the headset while driving, ensure your full attention and focus. It is your responsibility to drive safely. Consider to pull off the road before making or answering a call. Never leave your headset above any air bag deployment area inside your car as serious injury may result when an air bag deploys. Never allow children to play with the headset – small parts may be of choking hazard.
Do not attempt to modify the headset. Do not keep the headset near a wash basin or other wet places. Do not use the headset outdoors in the rain. Do not use the headset in stormy weather. Do not clean the headset while it is being charged. Always disconnect the charger from the headset before cleaning. Do not attempt to force open the built-in battery. Only charge the headset’s built-in battery in accordance with the instructions described in this user guide.
Federal Communications Commission (FCC) Statement BH60 complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Guarantee Yo u r a c c e s s o r y i s g u a r a n t e e d a g a i n s t a l l manufacturing defects for twelve (12) months from the date of purchase shown on your invoice. Nevertheless, if the legal warranty period in force in your country exceeds twelve (12) months, the legal warranty alone shall be applicable. Hot Line Number: see “TCT Mobile Services” leaflet or go to our Internet site. On our Internet site (www.alcatelonetouch.com), you will find our FAQ (Frequently Asked Questions) section.
ALCATEL is a trademark of Alcatel-Lucent and is used under license by TCL Communication Ltd.. © Copyright 2015 TCL Communication Ltd. All rights reserved TCL Communication Ltd. reserves the right to alter material or technical specification without prior notice.
Due to the used enclosure material, the product shall only be connected to a USB Interface of version 2.0 or higher. The connection to so called power USB is prohibited. The product is power by PC through USB port. CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS Excessive sound pressure from earphones and headphones can cause hearing loss. This device complies with Industry Canada license-exempt RSS standard(s).
