Technical Specifications

2025 Centre Pointe Blvd, Suite 300, Mendota Heights, MN 55120 | P 651.905.8137 | F 651.688.9164 | www.tccmaterials.com
PREMIUM CONCRETE
COUNTERTOP MIX
™
Fiber Reinforced ● Fast Setting ● High Strength ● Pourable
©TCC Materials
®
• April 2013 Version 2.1
imperfections or defects along the
edges prior to finishing.
Clean Up
Typically water will satisfactorily clean
tools after using Premium
Concrete
Countertop Mix
™
. If the material has
begun to harden, warm soapy water
may be helpful for cleaning hands and
tools.
Warranty:
Seller warrants that its product will
conform to and perform in accordance
with the product specifications. The
foregoing warranty is in lieu of all oth-
er warranties, express or implied,
including, but not limited to, those
including merchantability and fitness
for a particular purpose. Because of
the difficulty in ascertaining and
measuring damages hereunder, it is
agreed that, seller’s liability to the
buyer at no point for any particular
project shall exceed the total
purchase price of said product.
PRECAUTIONS:
Avoid contact with eyes and skin. If
contact with eyes occurs, flood eyes
repeatedly with clean water and see a
physician immediately. Do not rub
eyes. Wash hands thoroughly after
handling or before eating with warm,
soapy water. Do not take internally.
Keep out of reach of children.
Application
Make sure the form(s) are leveling
prior to pouring mixture. Fill the
pre-made form with the mixture
making sure it fills in around any
reinforcement. Vibrate the form by
tapping with a rubber mallet around
all the edges or by using a palm sand-
er without any paper on it. This is an
important step to minimize pin-
holes in the precast surface.
Curing
After the material in the form has
begun to take a set, normally 1 hour,
snip off the wire ties holding the wire
mesh just below the surface of the
countertop mix. If needed, screed the
back off, using a 2” x 4” moving it in a
sawing type movement against the
top of the side forms. Cover the
countertop mix with plastic and allow
it to cure 18-24 hours. Remove the
plastic from the countertop surface
and remove all the screws holding the
form together. The countertop will still
be very fragile so use care in
removing forms. If necessary, use
small wooded shims to help remove
the sides of the form. Put down some
small pieces of foam next to the base
of the form. Then hold the base of the
form and the countertop, lift the
countertop onto the foam in a vertical
position. Gently remove the bottom of
the base and gently remove any cut
outs. Using caution lay the top down
on foam scraps with the surface of the
countertop up. Using a sanding block
smooth all the edges and remove any
imperfections/defects.
Finishing
The surface of the countertop can be
wet polished or cleaned and sealed,
as is, depending on the desired
appearance. Follow all instructions for
the sealing products used. If pinholes
are present use a non sanded patch
to fill any pinholes or to touch up any
KEEP OUT OF REACH OF CHILDREN!
WARNING: INJURIOUS TO EYES!